Original
By certification 
Operating Instructions
The unit must be operated in an area that meets the following requirements in order to operate safely and provide optimum performance:
Description |
|
Dry |
Don’t allow water or other liquid to drop or splash on the unit. |
Cool |
Ambient air temperature should be between and (0℃~40℃) (the cooler the better within this range). |
Ventilated |
Leave at least 2in (5cm) clearance |
around the unit for air flow. Ensure that the ventilation openings are not obstructed. |
|
Safe |
Do not operate the unit in the same compartment as batteries or in any compartment capable of storing flammable liquids like gasoline. |
Clean |
Do not operate the unit in an area that is prone to dirt, dust or debris. Especially important if used in a work environment. |
Your Pure Sine Wave Inverter supplies of 100% continuous power as rated, and the surge power will be twice as rated power. When you turn on an appliance or a tool that operates using a motor or tubes, it requires an initial surge of power to start up. This surge of power is referred to as the "starting load" or "peak load". Once started, the tool or appliance requires less power to continue to operate. This is referred to as the "continuous load" in terms of power requirements. You will need to determine how much power your tool or appliance requires to start up and its continued running power requirements.
The inverter should be connected to your 12V (or 24V) power source with the DC cables (included). We recommend that the equipment or appliance switch be in the "OFF" position prior to plugging into the AC receptacle of the inverter.
Using the DC Cable-Ring Terminal
Due to limitations in the common 12V DC (or 24V) outlet in a vehicle or boat, the inverter should only be used to supply AC power to products that require the rated power or less. If your application requires more than the continuous power (but less than the rated power) or has a high start-up surge, see using the DC Cable-Clips.
1. Attach the ring type connector marked with red to the positive (+) DC terminal on the inverter and attach the ring connector marked with black to the negative (-) DC terminal.
2. Tighten the nut on each DC terminal by hand until it is snug. Do not over tighten.
3. Insert the plug of this cable into the 12V DC (or 24V DC) outlet and switch the unit ON. See Section 4 if the inverter does not operate properly after being connect.
4. When the inverter is not in use, unplug it from the 12V DC (or 24V DC)outlet to prevent slight discharge of the Battery.
Using the Dc Cable-Clips
By directly connecting the inverter to a 12V DC(or 24V DC)battery with DC Cable-Clips, you can operate products with power requirements up to rated continuous output power. If you want to permanently connect the inverter to a battery, please use Ring Terminals.
1. Follow steps 1 and 2 above (Using the DC Cable-Ring Terminal)
2. To attach the ring type connectors.
3. Attach the black negative clip to negative (-) battery terminal.
4. Attach the red positive clip to the positive (+) battery terminal. Make sure both clips are securely connected to the battery terminals, as a loose connection will cause excessive voltage drop and may cause the cables to overheat resulting in equipment damage or fire.
5. Switch the inverter ON. See section 4 if the inverter does not operate properly after being connected.
6. When the inverter is no in use, disconnect the DC Cable-Clips from the battery.
http://www.raenchidz.com/
